Slotted Flap
The most popular flap on aircraft today is the slotted flap.
Variations of this design are used for small aircraft, as well as for large ones.
Slotted flaps increase the lift coefficient significantly more than plain or split flaps.
On small aircraft, the hinge is located below the lower surface of the flap, and when the flap is lowered, a duct forms between the flap well in the wing and the leading edge of the flap.
When the slotted flap is lowered, high energy air from the lower surface is ducted to the flap’s upper surface.
The high energy air from the slot accelerates the upper surface boundary layer and delays airflow separation, providing a higher CL.
Thus, the slotted flap produces much greater increases in maximum coefficient of lift (CL-MAX) than the plain or split flap.
While there are many types of slotted flaps, large aircraft often have double- and even triple-slotted flaps.
These allow the maximum increase in drag without the airflow over the flaps separating and destroying the lift they produce.
Fowler flaps are a type of slotted flap.
This flap design not only changes the camber of the wing, it also increases the wing area.
Instead of rotating down on a hinge, it slides backwards on tracks.
In the first portion of its extension, it increases the drag very little, but increases the lift a great deal as it increases both the area and camber.
Pilots should be aware that flap extension may cause a nose-up or down pitching moment, depending on the type of aircraft, which the pilot will need to compensate for, usually with a trim adjustment.
As the extension continues, the flap deflects downward.
During the last portion of its travel, the flap increases the drag with little additional increase in lift.
'PHAK' 카테고리의 다른 글
PHAK Chapter 6-18 Spoilers (0) | 2021.08.18 |
---|---|
PHAK Chapter 6-17 Leading Edge Devices (0) | 2021.08.17 |
PHAK Chapter 6-15 Secondary Flight Controls (0) | 2021.08.15 |
PHAK Chapter 6-14 V-Tail (0) | 2021.08.14 |
PHAK Chapter 6-13 Rudder (0) | 2021.08.13 |
댓글